Go to the web interface of the device and enable the Gateway Access under ConfigurationàXBee NetworkàGateway Access as shown below:
![](http://ftp1.digi.com/support/images/x2rp1.png)
Note: Make sure the baud rate of the XBee module is not changed from the default rate of 115200.
Download the Digi RealPort driver at the following link: http://www.digi.com/support/productdetail?pid=3037&type=drivers, select the desired operating system.
![](http://ftp1.digi.com/support/images/x2rp2.png)
For Windows, unzip the file and select the setup32(32 bit OS)or setup64(64 bit OS). The following will display:
![](http://ftp1.digi.com/support/images/x2rp3.png)
Select the device:
![](http://ftp1.digi.com/support/images/x2rp4.png)
Select the COM port:
![](http://ftp1.digi.com/support/images/x2rp5.png)
![](http://ftp1.digi.com/support/images/x2rp6.png)
Click Finish when complete:
![](http://ftp1.digi.com/support/images/x2rp7.png)
Open X-CTU (may be downloaded from the following link: http://www.digi.com/support/productdetail?pid=3352&type=utilities):
![](http://ftp1.digi.com/support/images/x2rp8.png)
Select the COM port which you specified while installing RealPort, specifiy 115200 for the baud rate and click Finish:
![](http://ftp1.digi.com/support/images/x2rp9.png)
![](http://ftp1.digi.com/support/images/x2rp10.png)
Click configuration Working Mode:
![](http://ftp1.digi.com/support/images/x2rp11.png)
You will see a list of parameters as shown below:
![](http://ftp1.digi.com/support/images/x2rp12.png)